Adcom GFR-700 - Remote Control Setup

42
Chapter 3 - Setup
GFR-700 Owner’s Manual
Remote Control Setup
The GFR-700 is a learning remote control that is ca-
pable of storing and executing commands for all re-
mote controls in your home theater system. In this
way, you can eliminate the confusion of using mul-
tiple remotes.
This section is divided into two main parts:
Using Preprogrammed Commands
The first section is an overview of the preprogrammed
commands for each source:
• Main commands ................................... 39
• Video 1~3 commands ............................. 39
• Video 4 commands (GDV-850) ................... 40
• CD commands (GCD-750) ......................... 40
• Tuner commands .................................. 41
• Rm 2 commands ................................... 41
Note: Main commands are not programmable, except
for the four user macros (M1, M2, M3, and M4).
Programming Remote Commands
The second section includes instructions for pro
-
gramming the remote for each source:
• Programming commands ......................... 39
• Deleting commands ............................... 40
• Deleting all commands for a
single component ................................. 41
• Deleting all commands for
all components .................................... 41
• Programming macro buttons .................... 41
• Deleting macro buttons .......................... 42
• Discrete remote control commands ............ 42
Pressing a source button on the remote con-
trol not only selects the input associated
with that source...
...but it also remaps the remote control
buttons for that source.