ADLINK Technology VPX3-TL BIOS - Page 47

47
VPX3-TL BIOS
Parity
None, Even, Odd, Mark,
Space
Configures if parity bit is generated
(transmit data) or checked.
A parity bit can be sent with the data bits to
detect some transmission errors. Even:
parity bit is 0 if the num of 1's in the data
bits is even. Odd: parity bit is 0 if num of 1's
in the data bits is odd. Mark: parity bit is
always 1. Space: Parity bit is always 0. Mark
and Space Parity do not allow for error
detection. They can be used as an additional
data bit.
Stop Bits
1
2
Configures the number of stop bits
transmitted and received in each serial
character for both serial ports.
Stop bits indicate the end of a serial data
packet. (A start bit indicates the beginning).
The standard setting is 1 stop bit.
Communication with slow devices may
require more than 1 stop bit.
Flow Control
None, Hardware
RTS/CTS
Configures flow control for console
redirection. Hardware flow control uses
RTC/CTS. Software flow control uses
XON/XOFF.
VT-UTF8 Combo Key
Support
Disabled
Enabled
Enable VT-UTF8 combination key support
for ANSI/VT100 terminals.
Recorder Mode
Disabled
Enabled
With this mode enabled only text will be
sent. This is to capture terminal data.
Resolution 100x31
Disabled
Enabled
Enables or disables extended terminal
resolution.
Putty KeyPad
VT100
LINUX
XTERMR6
SCO
ESCN
VT400
Select Function Keys and Key Pad on Putty.