41
VPX3-TL BIOS
3.9 VPX Configuration
Aptio Setup – AMI
Advanced
VPX Configuration
WOL From S5 [ON]
Active Cooling Trip Point [Refer to BMC]
Passive Cooling Trip Point [Disabled]
Critical Trip Point [Disabled]
Watchdog ACPI Event Shutdown [Disabled]
PCIE_BFR_SEL [1x8 + 2x4]
GPIO Pin Direction [Input Mode]
GPIO Interrupt Setting [No interrupt]
EC_GPI0 [Interrupt trigger]
EC_GPI1
[Interrupt trigger]
EC_GPI2 [Interrupt trigger]
EC_GPI3 [Interrupt trigger] ><: Select Screen
EC_GPO0 [Low] ^v: Select Item
EC_GPO1 [Low] Enter: Select
EC_GPO2 [Low] +/-: Change Opt.
EC_GPO3 [Low] F1: General Help
COM2 port mode [RS232] F8: Previous Values
Maintenance port mode [UART] F9: Optimized Default
DP++ manual mode [Displayport] F10: Save & Exit
PCIe Scan Delay 0 ESC: Exit
BIOS Item Options Description
WOL From S5
OFF
ON
This Config to control power on/off LAN in
S5 State by SEMA(EC).
Active Cooling Trip Point
40 C, 50 C, 60 C, 70 C,
Refer to BMC
This value is the temperature threshold of
the active cooling trip point.
Passive Cooling Trip Point
Disabled, 70 C, 80 C,
90 C
This value is the temperature threshold of
the passive cooling trip point.
Critical Trip Point
Disabled, 80 C, 90 C,
95 C
This value is the temperature threshold of
the critical trip point.
Watchdog ACPI Event
Shutdown
Disabled
Enabled
Watchdog ACPI Event Shutdown
Enabled/Disabled
PCIE_BFR_SEL
1x8 + 2x4, 2x8 Refer to the following information for
customized functions
GPIO Pin Direction
Input Mode
Output Mode
Indicates whether the GPIO Pin is
interrupted. Write 0x00 to clear the
interrupt and EC_GPIO_INT will be
changed to high level
GPIO Interrupt Setting
No interrupt,
Interrupt for both
edge trigger, Low
level trigger, High
level trigger
When GPIO Pin is input mode, it supports
edge trigger and level trigger
To Next Page
Loading...
