ADLINK Technology VPX3-TL BIOS - Graphics Configuration

55
VPX3-TL BIOS
BIOS Item Options Description
Controller 0, Channel 0
DIMM Control
Enable both DIMMs,
Disable DIMM0,
Disable DIMM1,
Disable both DIMMs
Controller 0, Channel 0 DIMM Control
Support - Enable or Disable Dimms on
Controller 0, Channel 0.
Controller 1, Channel 0
DIMM Control
Enable both DIMMs,
Disable DIMM0,
Disable DIMM1,
Disable both DIMMs
Controller 1, Channel 0 DIMM Control
Support - Enable or Disable Dimms on
Controller 1, Channel 0.
In-Band ECC Support
Disabled, Enabled Enable/Disable In-Band ECC. Either the
IBECC or the TME can be enabled.
4.1.2 Graphics Configuration
Aptio Setup – AMI
Chipset
Graphics Configuration
Skip Scaning of External Gfx Card [Disabled]
Primary Display [Auto]
Select PCIE Card [Auto]
> External Gfx Card Primary Display Configuration
Internal Graphics [Auto]
GTT Size [8MB]
Aperture Size [256MB]
DVMT Pre-Allocated [60MB]
DVMT Total Gfx Mem
[256MB]
Intel Graphics Pei Display Peim [Disabled]
><: Select Screen
^v: Select Item
Enter: Select
+/-: Change Opt.
F1: General Help
F8: Previous Values
F9: Optimized Default
F10: Save & Exit
ESC: Exit
BIOS Item Options Description
Skip Scaning of External
Gfx Card
Disabled
Enabled
If Enable, it will not scan for External Gfx
Card on PEG and PCH PCIE Ports
Primary Display Auto, IGFX, PEG Slot,
PCH PCI, HG
Select which of IGFX/PEG/PCI Graphics
device should be Primary Display Or select
HG for Hybrid Gfx.