4-5
FIELD TITLE and DATA ENTRIES EXPLANATION
*60
Trouble Report Code
0 = no report
1st digit non-zero = send report
This will be sent if a zone has a trouble condition.
*61
Bypass Report Code
0 = no report
1st digit non-zero = send report
This will be sent when a zone is manually bypassed.
*62
AC Loss Report Code
0 = no report
1st digit non-zero = send report
Timing of this report is random with up to a 4-hour delay. If AC
restores before the report goes out, there is no “AC RESTORE”
report.
*63
Low Bat Report Code
0 = no report
1st digit non-zero = send report
This will be sent when a low-battery condition exists in the system’s
standby battery.
*64
Test Report Code
0 = no report
1st digit non-zero = send report
This is sent periodically to test that the communicator and phone
lines are operational. Frequency of report is set using Scheduling
mode (event 11).
*65
Open Report Code
0 = no report
1st digit non-zero = send report
This is sent upon disarming of the system in the selected partitions.
*66
Arm Away/Stay Report Code
0 = no report
1st digit non-zero = send report
This option allows for independent programming of Away and Stay
reports for each partition, including the common lobby.
NOTE: “OPEN” reports are not sent if the associated closing report
is not enabled.
*67
RF Trans. Low Batt. Report Code
0 = no report
1st digit non-zero = send report
This is sent in the event that a wireless transmitter low-battery
condition exists.
*68
Cancel Report Code
0 = no report
1st digit non-zero = send report
This is sent upon disarming of the system after an alarm condition
was reported.
Restore Report Codes (
∗
70–
∗
76)
FIELD TITLE and DATA ENTRIES EXPLANATION
*70
Alarm Restore Report Code
0 = no report
non-zero = send report
This is sent when the zone that caused an alarm is restored to its
non-faulted condition.
*71
Trouble Restore Report Code
0 = no report
1st digit non-zero = send report
This is sent when a trouble in a zone is restored
*72
Bypass Restore Report Code
0 = no report
1st digit non-zero = send report
This is sent when a zone that has been bypassed is unbypassed.
*73
AC Restore Report Code
0 = no report
1st digit non-zero = send report
This is sent when AC power has been restored after an AC power
outage.
*74
Low Bat Restore Report Code
0 = no report
1st digit non-zero = send report
This is sent when a system low-battery condition is restored to
normal.
*75
RF Xmtr Low Batt. Restore Code
0 = no report
1st digit non-zero = send report
This is sent when a transmitter that previously sent in a “LOW
BATTERY” message has sent a message indicating it no longer has a
low-battery condition.
*76
Test Restore Report Code
0 = no report
1st digit non-zero = send report
This is sent when the Test mode is exited.
To Next Page
Loading...
Need help?
General
