12-1
SECTION 12
System Operation
•••••••••••••••••••••••••••••••••••••••
Security Codes
The system supports up to 48 security codes, which can each be assigned one of 5 authority levels.
The authority level determines the functions a particular user code can perform as follows:
Authority Levels
Level Functions
Installer (user 01) perform all security functions except can disarm only if used to arm;
can enter program mode; cannot change hidden installer code (default=6321)
Master (user 02) only one master code per system; can perform all security functions, add/delete
users in either partition, change master code, view event log, set system clock,
program keypad macro, program scheduled events, activate output devices
(triggers/relays)
Part. Programmer same as Master, except add/delete users limited to assigned partition
(user 03/user 33) only, where user 03 = partition 1; user 33 = partition 2
(these users can be assigned different authority levels, if desired)
0-User perform security functions (arm, disarm, etc.) only; cannot add/delete users,
view event log, set system clock or program scheduled events
1-Arm Only arm system only
2-Guest can disarm the system only if it was used to arm the system
3-Duress performs security functions, but also silently sends a duress message to the
central station; reports as zone 92
4-Partition Prog. see Partition Programmer paragraph above; use to assign other user numbers
as partition programmers
Refer to the user guide for procedures on adding/deleting security codes. The following is a brief
description of how to add user codes.
Adding a User Code: Master/Part. Prog. code + [8] + 2-digit user no. + user’s code
Deleting a User Code: Master/Part. Prog. code + [8] + 2-digit user no. + [#] [0]
Assigning Attributes: Master/Part. Prog.
†
code + [8] + 2-digit user no. + [#] [attribute no.] + value
Attributes:
1 = Authority Level (0-4) [see Authority Level table above]
2 = Access Group (0-8)
3 = Active Partition(s) for this user (1, 2, 3 [common] ); enter partitions consecutively
if more than one and press [#] to end the entries
4 = RF Zone No. (assigns user number to button type zone for arm/disarm)
5 = Open/Close Paging (1 for yes, 0 for no)
† Partition Programmer cannot assign parititions.
To Next Page
Loading...
Need help?
General
