Safewatch Pro 3000 Installation Instructions
4-8
Pager Programming Fields
FIELD TITLE and DATA ENTRIES EXPLANATION
*160
Pager #1 Phone No.
Enter up to 20 digits
If you enter fewer than 20 digits, exit by pressing [
∗
] and next field
number. To clear entries from this field, press
∗
160
∗
.
*161
Pager #1 Characters
Enter up to 16 characters
Up to 16 optional characters may be sent as a prefix to the 7-digit
system status code sent to pager #1 (if used). Phone number in field
*160 must have been entered. If fewer than 16 characters, exit by
pressing [
∗
] and next field number. To clear entries from this field,
press
∗
161
∗
.
For example, these optional 16 characters may be composed of the
following:
•
PIN number (to identify a specific pager to the paging company)
•
Subscriber account number
•
∗
(enter # + 11 to send
∗
)
•
# (enter # + 12 to send #)
•
Pause (enter # + 13 to allow a 2-second pause)*
•
Any special character(s) the end user may decide to transmit
* Some paging systems require pause(s) before the prefix.
The format for the 7-digit system status code is defined as follows:
Pager Format: XXX-YYYY where:
XXX = 3-digit event code: 911 = Alarm
811 = Trouble
101 = Opening (disarm)
102 = Closing (arm AWAY)
YYYY = 4-digit user or zone number (depending on type of event).
The first two digits must always be 00, and must be
followed by the 2-digit user or zone number.
Example 1.
Pager displays:
911–0004
This indicates that the system is reporting an alarm (911) caused by
a fault in zone 4 (0004).
Example 2.
Pager displays:
102–0005
This indicates that the system is reporting a closing–system arming
(102) by User 5 (0005).
*162
Pager 1 Reports
0 = No reports sent
1 = Open/close for all users enabled to page
4 = All alarms and troubles
5 = All alarms, troubles, and open/close for
all users enabled to page
12 = Alarms and troubles for zones entered
in zone list 9
13 = Alarms and troubles for zones listed in
zone list 9 and open/close for all users
enabled to page
Enter the types of reports to be sent to pager 1 for each partition.
*163
Pager 2 Phone No.
Enter up to 20 digits
If you enter fewer than 20 digits, exit by pressing [
∗
] and next field
number. To clear entries from this field, press
∗
163
∗
.
*164
Pager 2 Characters
Enter up to 16 characters
See field
∗
161 for explanation of entries. If fewer than 16 characters,
exit by pressing [
∗
] and next field number. To clear entries from this
field, press
∗
164
∗
.
*165
Pager 2 Reports
see pager 1 reports, field *162 for entries,
except use zone list 10.
Enter the types of reports to be sent to pager 2 for each partition.
To Next Page
Loading...
Need help?
General
