Safewatch Pro 3000 Installation Instructions
12-4
Alpha Display Fixed Disp. Meaning
Modem Comm CC
The system is in communication with the central station for change of function or
status verification.
no display no display
Power Failure
If there is no touchpad display at all and the LEDs are unlit, operating power (AC
and battery) for the system has stopped and the system is inoperative.
If the message “AC LOSS” (Custom English display touchpads) or “NO AC”
(English display touchpads) is displayed, the touchpad is operating on battery
power only.
If the battery standby capacity is used up during a prolonged AC power outage,
the control's power will shut down to minimize deep discharge of the battery.
Comm. Failure FC
A communication failure has occurred.
Open Circuit OC
The touchpad is not receiving signals from the control and sees an open circuit.
Long Rng Trbl bF
Backup LRR communication failure.
Bell Failure
70
Bell supervision failure.
RCVR Jam
90
RF jam detected.
KEYPAD LOW BAT 00 BAT
Wireless touchpad low battery
Phone Okay dO
the dialer test has been successful
Test in Progress dd
Walk test mode is active
Upload Completed dC
the upload or download session was completed
Upload Failed dF
the upload or download session failed before completion