ADT Unimode 9600 - 3.6.1 Point Program

0DVWHU3URJUDPPLQJ/HYHO 3URJUDPPLQJ
8QLPRGH31& 
3.6.1 Point Program
The Point Program option allows the programmer to add a new addressable device to an
SLC loop, delete an existing device from a loop or change the programming for an
existing device. Pressing 1, while viewing Programming Screen #1, will select the Point
Program option and display the following screen:
The programmer selects the desired SLC loop by pressing 1 or 2 in Point Program Screen
#1, which causes the panel to display the following screen:
3.6.1.1 Detector Programming
3UHVVLQJZKLOHYLHZLQJ3RLQW3URJUDP6FUHHQZLOODOORZWKHSURJUDPPHUWRDGG
GHOHWHRUFKDQJHWKHSURJUDPPLQJRIDQDGGUHVVDEOHGHWHFWRU7KHIROORZLQJVFUHHQ
ZLOOEHGLVSOD\HGE\WKHFRQWUROSDQHO
3.6.1.1.1 Add Detector
3UHVVLQJZKLOHYLHZLQJWKH'HWHFWRU6FUHHQZLOOGLVSOD\WKHIROORZLQJVFUHHQZKLFK
DOORZVWKHSURJUDPPHUWRDGGDQHZGHWHFWRUDGGUHVVWRSURJUDPPLQJ
$IODVKLQJFXUVRUZLOODSSHDULQWKHSRVLWLRQRIWKHILUVWDVWHULVNWRWKHOHIW7KH
SURJUDPPHUNH\VLQWKHWKUHHGLJLWGHWHFWRUDGGUHVVVXFKDV
PROGRAMMING
1=POINT PROGRAM
2=ZONE SETUP
3=LOOP SETUP
Programming Screen #1
@@@POINT@PROGRAM
@@@@SELECT@LOOP
1=LOOP@1
2=LOOP@2
Point Program Screen #1
@@@POINT@PROGRAM
@@@@SELECT@TYPE
1=DETECTOR
2=MODULE
Point Program Screen #2
@@@@@@DETECTOR
1=ADD
2=DELETE
3=EDIT
Detector Screen


@@@@ADD@DETECTOR
ENTER@DETECTOR#
***
Add Detector Screen