0DLQWHQDQFH3URJUDPPLQJ/HYHO 3URJUDPPLQJ
8QLPRGH31&
3.7 Maintenance Programming Level
To access Maintenance Programming mode, press the Enter key. The LCD will display
the following:
To enter the Maintenance Programming mode, press 2. The display will read as follows:
When the Maintenance
level password (default 11111) is entered, the following screen
will appear:
Note that in the preceding screens, an arrow appears to inform the programmer that
additional options can be viewed by pressing the keypad down arrow key, as shown in the
following screen.
1=READ@STATUS
2=PROGRAMMING
PROGRAMMING
ENTER@PASSWORD
@@@@PROGRAMMING
1=POINT@PROGRAM
2=HISTORY
3=PROGRAM@CHECK
@@@@PROGRAMMING
1=WALKTEST
2=SYSTEM
3=ZONE@SETUP
To Next Page
Loading...
Need help?
General
