ADT Unimode 9600 User Manual

0DVWHU3URJUDPPLQJ/HYHO 3URJUDPPLQJ
8QLPRGH31& 
$VDQH[DPSOHWKHXVHUFRXOGTXLFNO\HQWHUµ)/5BB5220¶DVIROORZV
1. The cursor is on the first letter of the Adjective field. Press the zero key twice to
display FLR_3
2. With the cursor on the first letter of the Noun field, press the zero key twice to recall
the display ROOM_304. The cursor automatically jumps from the first to the last
letter of the Noun field
3. With the cursor on the last letter of the Noun field, press the zero key again to
increment the room number to 305
4. Press the right arrow key to advance the zone field
5. Select a zone number from 00 to 99. Z00 (default zone) is the general alarm zone.
Z01 through Z99 may be selected to link software zones
3.6.1.2.4 Edit Module Screen for Control Modules
7KHSURJUDPPHUFDQFKDQJHDPRGXOH¶VH[LVWLQJRUIDFWRU\GHIDXOWSURJUDPPLQJE\
SUHVVLQJLQWKH0RGXOHV6FUHHQ7KHIROORZLQJVFUHHQZLOOEHGLVSOD\HG
$IODVKLQJFXUVRUZLOODSSHDULQWKHSRVLWLRQRIWKHILUVWDVWHULVNWRWKHOHIW
7KHSURJUDPPHUNH\VLQWKHWKUHHGLJLWPRGXOHDGGUHVVVXFKDV:KHQWKHODVW
GLJLWLVNH\HGLQLIWKHVHOHFWHGDGGUHVVFRUUHVSRQGVWRDFRQWUROPRGXOHDVFUHHQ
GLVSOD\LQJLQIRUPDWLRQDERXWWKHFRQWUROPRGXOHZLWKWKHVHOHFWHGDGGUHVVZLOOEH
GLVSOD\HGDVLOOXVWUDWHGLQWKHIROORZLQJ
,QWKHSUHFHGLQJH[DPSOH
✓ Normal - indicates that the module with the selected address is physically
installed on the SLC and communicating with the control panel (enabled)
✓ <ADJ><NOUN> - represents the adjective and noun, which have been
programmed, describing the location of the displayed device
✓ Control - indicates that the selected module is a control module
✓ S or * - represents Silenceable (S) or Nonsilenceable (*)
✓ W or * - represents Waterflow Timer Delay (W = Waterflow Timer Delay
enabled, * = Waterflow Timer Delay disabled)
✓ ZNNN - represents the first of five possible software zones that the module is
assigned to (NNN = the three digit zone number from 000 - 099)
✓ 1M002 - represents the Loop, Device type and Device address (1 = SLC Loop 1,
M=Module and 002 = Module Address 02)
MODULES
1=ADD
2=DELETE
3=EDIT
Modules Screen


@@@@EDIT@MODULE
ENTER@MODULE@ADDRESS
***
Edit Module Screen
NORMAL@@@@@@CONTROL
@@@@@@<ADJ><NOUN>
@@@@@@@@@@SW@@ZNNN
@@@@@@@@@@@@@@1M002
Edit Control Screen #1

ADT Unimode 9600 Specifications

General

Brand	ADT
Model	Unimode 9600
Category	Control Panel
Language	English