ADTECH9 Series CNC Maintenance Manual
- 178 -
Unit : None
Authority : Operation admin or higher
Default : 100
Effective time : Instant
Note : Set tapping F to indicate rate or logic programming method
10.7
Port configuration (P6.)
001 Tool Checking Signal Port No.
… …
046 Oil Pump Out Port No.
075 Handwheel 0.1
… …
088 SCRAM
Range : 0~23
Unit : Terminal No.
Authority : Super Admin
Default : The port table in the manual
Effective time : Instant
Note : Set the input or output port number assigned to configure system
functions;
To shield this function, you can type 8888 and press Insert. This
operation is in background, and displays “=========” if the operation
is successful.
047 Input Detect ELevel 00 ~ 31
048 Input Detect ELevel 32 ~ 63
049 Input Detect ELevel 64 ~ 95
050 Input Detect ELevel 96 ~ 127
051 Input Detect ELevel 128 ~ 159
052 Input Detect ELevel 160 ~ 191
053 Input Detect ELevel 192 ~ 223
To Next Page
Loading...
Need help?
General
