Name: Adtech CNC9650
Brand: Adtech
Rating: 5 (1 reviews)

To Next Page

To Previous Page

ADTECH9 Series CNC Maintenance Manual

- 26 -

When auxiliary output is on, if the system is switched to other modes, the output is unchanged; you need to press

“Reset” key to switch it off, execute the corresponding M code in automatic mode or execute the corresponding

M code in MDI interface to turn off the output;

When the spindle is positive/reverse rotating and execute M04/M03 directly, the system first stops

positive/reverse rotating and then execute M04/M03 instruction;

Positive/reverse rotating of principal is stopped while emergency stop, and other outputs can be set according to

system parameters.

3.10

Tool setting

Tool setting is the main operation and important skill during CNC processing. Under certain conditions, tool

setting precision can determine the processing precision of parts, and the tool setting efficiency also affects the

CNC processing efficiency directly. CNC96XX has M series tool setting mode and L series tool setting mode,

while M series has two tool setting methods, i.e. centered and tool regulator, and L series uses test cutting.

3.10.1. Centered (M series)

The centered function is that the system calculates the center position of the workpiece automatically while tool

setting to realize segment centered, rectangle centered and circle center location.

) Note

In the tool setting operation below, if the auxiliary parameters of the coordinate system doesn’t need setting, the

first three steps can be omitted. Please refer to chapter 9.5 for auxiliary parameters of the coordinate system.

⑴ Single axis centered

Select the edit mode;

Press [Coordinates], [Coordinates Parameter] to enter the auxiliary parameters setting interface of the

coordinate system;

Move the cursor to desired position, enter new parameters and press [EOB];

Select handwheel or manual mode;

Press [Coordinates] to enter coordinate system setting interface;

Press the left/right arrow to move the cursor to select coordinate system;

Press [Centered Measurement] to enter centered interface;

Move the tool to make its side blade touch side A surface of the workpiece, and press [EOB] to record

boundary point 1;

Move the tool to make its side blade touch side B surface of the workpiece, and press [EOB] to record

boundary point 2;

Press [EOB] to calculate the coordinates of center point;

Adtech CNC9650 User Manual

Other manuals for Adtech CNC9650