ADTECH9 Series CNC Maintenance Manual
- 85 -
9.
System maintenance
9.1
Restart
⑴ In the main menu, press [Edit] to enter the program interface;
⑵ Press [File] to enter the file interface;
⑶ Press [Reset] and the system will ask whether to restart or not;
⑷ Press [OK] to restart the system.
9.2
System upgrade
The steps of copying upgrade program with USB disk are as follows:
⑴ In the main menu, press [Edit] to enter the program interface;
⑵ Press [File] to enter the file management interface;
⑶ Insert the USB disk, select the USB disk symbol in the root directory to open the USB disk; after reading
successfully, the system will enter the USB directory automatically;
⑷ Move cursor to the upgrade file ADTROM.BIN, select [Copy], enter ADT directory in disk C and paste it;
⑸ Select the second upgrade file NC_RES.NC; skip this step if the file doesn’t exist. Also select Copy, enter
disk C, and paste it in directory ADT.
(6) After upgrading, enter BIOS, select [Boot-up mode] to startup, and restart the system to validate the program
in disk D.
(7) Enter System Info in Diagnosis menu to view the system version and compilation date, and check whether
the upgrade is successful.
9.3
Reset
⑴ Select the edit mode;
⑵ In the main menu, press [Parameter] to enter the parameter interface;
⑶ Press [Management] key to enter management parameter interface;
⑷ Move cursor to “006 Reset all parameters”;
⑸ Press [EOB], the system confirms, restores the default parameters and restarts automatically.
9.4
Parameter backup and restore
⑴ Select the edit mode;
⑵ In the main menu, press [Parameter] to enter the parameter interface;
⑶ Press [Management] key to enter management parameter interface;
To Next Page
Loading...
Need help?
General
