ADTECH9 Series CNC Maintenance Manual
- 38 -
indicates that high level is detected as 1, then confirm whether the corresponding parameter level is correct. If
the setting is wrong, the scanning speed and direction will work abnormally.
2. After the scanning is finished, confirm whether the compensation value is correct by moving the
machine to the workpiece zero point.
3.14.3. Tool setting by test cutting (L series)
The machine tool uses test cutting for tool setting, which moves the tool to cut the processing file, measures the
value after cutting and enters into the system to complete the tool setting for center point.
For tool setting by test cutting, enter the test cutting interface first.
Press [Coordinate], [Tool Setting] to enter tool setting interface;
Move cursor to desired tool number, and select diameter or length for the type of current test cutting;
Select handwheel, single-step or manual mode;
Press the spindle on, and then press [X+] [X-] [Z+] [Z-] to move the axis and test cutting the workpiece;
After test cutting, turn off the spindle but do not move the axis;
Select edit mode, measure corresponding data and display data, press the number keys to enter directly,
press [EOB] to calculate and save automatically, or press [Cancel] to exit;
0 Caution
1. For tool setting by test cutting, automatically calculate the entered measurement value plus current
machine tool coordinates and then enter. Therefore, the current position of machine tool must be
true.
2. When measuring the diameter of workpiece, test cutting a layer of the workpiece surface. After
cutting, the axis can only retract in opposite direction. Do not move X axis, or else the measured
diameter will be invalid.
3. Measure the length of the workpiece, touch the workpiece end with the tool, make it can be cut;
enter length value 0, indicating that current point is the workpiece home of Z axis.
3.15
Data settings
3.15.1. Tool compensation data settings
The tool compensation parameters can be set as follow:
Select the edit mode;
In the main menu, press [Coordinate], and then press submenu [Compensation] to enter tool compensation
parameter setting interface;
To Next Page
Loading...
Need help?
General
