ADTECH9 Series CNC Maintenance Manual
- 41 -
4.
Automatic Operation
The machine tool moving according to prepared program is called as automatic operation. The automatic
operation modes of CNC96XX, CNC98XX and CNC99XX system follow:
Memory operation, MDI operation, USB disk DNC operation.
4.1
Memory operation
The machine tool can operate according to the program in CNC96XX memory, which is called as memory
operation.
The program is prestored in the memory. Select and load a program with the operation panel and press the “Start”
key to start the automatic operation. Then, press “Pause” key to pause, press “Start” key again to resume the
operation, and press “Reset” during operation to stop the program immediately.
The steps of memory operation are as follows:
⑴ Save the program in the memory (see 8.1 for details);
⑵ Select [Edit], [File] in the menu or press [File] on the panel to enter file operation interface;
⑶ Press the direction keys to move the cursor, press [EOB] to select a program and load the file into the work
area;
⑷ Press mode selection key [Auto] to switch to automatic mode;
⑸ Press the [Start] key to run the program, and the indicator is on.
4.2
MDI operation
In [Monitor] interface, switch to [MDI], enter the program with keypad and make the machine tool operate
according to the program. The program block isn’t saved in system memory, and can’t be preserved upon power
failure. This is called as MDI operation and the steps are as follows:
⑴ Press mode selection key [Edit];
⑵ Select [Monitor], [MDI] in the menu to enter MDI interface;
⑶ Enter program block instruction manually;
⑷ Press [Start], [EOB] to start executing the program block.
4.3
USB disk DNC
The program read from external USB disk can operate the machine tool without saving in CNC memory. This
operation is called as USB disk DNC operation.
The steps of USB disk DNC operation are as follows:
To Next Page
Loading...
Need help?
General
