User Manual of TV5600-B01 Series Dispensing Control System
Idle travel speed: the speed at which each axis moves when no glue is dispensed.
Track speed: The speed of the interpolation movement when dispensing.
1) Idle travelstarting speed: the speed when idle travelstarts; it should not be
set too large
2) Acceleration: The acceleration required from the starting speed to the idling
speed. If set to 0, the track speed is used for uniform processing
3) Idle travelspeed: the speed duringidle travel
1) Track starting speed: Starting speed when performing track processing
2) Track speed: The speed at which the track is interpolated
3) Track acceleration: The acceleration required from the starting speed to the
track speed. If set to 0, the processing is performed at a constant speed
1) Z-axis lifting start speed: The starting speed that Z-axis lifts
2) Z-axis lifting acceleration: The acceleration that Z-axis lifts
3) Z-axis lifting speed: The speed that Z-axis lifts
4) Z-axis descending speed: The speed at which the Z-axis descends
7.02 Glue open/close parameters
1. ->In handheld box file parameter interface -> press [ Open / Close glue] -> enter
parameters
To Next Page
Loading...
Need help?
General
