OsmoPRO MAX Automated Osmometer User Guide
84
Modifications made to this product that are not expressly approved in writing by the manufacturer will void the user’s
authority to operate this product, previously issued factory approvals, and the user’s rights under the warranty.
The distributor or dealer may have applied additional local, national, or international approvals to this product. Consult the
distributor or dealer for more information and documentation.
RFID Statement This product contains an RF Module:
FCC ID: E36-0005
IC: 20739-BISM410
Frequency: 13.56MHz
Tx Power: <68 dBuv @ 3.0 m
A copy of the Declaration of Conformity is available upon request.
Symbol definitions
The following list of symbols is for reference only. Not all symbols shown may be used on this instrument or in the
accompanying documentation.
This symbol indicates conformity to relevant European directives.
This symbol indicates the product was tested to conform to relevant Canadian and U.S. safety standards by Intertek
Testing Services NA, Inc. The ETL mark is approved in the United States as a Nationally Recognized Testing Lab
(NRTL) by OSHA, and in Canada by the Standards Council of Canada.
This symbol indicates the product conforms to the requirements of EU Directive 2012/19/EU on “Waste Electrical
and Electronic Equipment” when disposed of in accordance with the provisions described in this guide.
Protective Earth Ground
Indicates a carrier that contains
unique device identifier information
Alternating Current (AC)
On-O Fuse Lifting Hazard
Dangerous Voltage Attention Handle with Care
Do Not Open Top Calibrator Use Blade to Open
Fragile Control Do Not Re-Use
Sensitive to Static Electricity Toxic Temperature Limit
Appendix D: Regulatory Notices
To Next Page
Loading...
Need help?
General
