5. Remove the existing EPROM by holding it top to bottom and carefully remove.
6. When installing new EPROM, insert with notch facing upwards and carefully inset into
socket.
7. Change the MODE SELECTOR switch from RUN to PROGRAM and turn power ON.
8. Turn power to OFF, and turn MODE SELECTOR switch to REMOTE and turn power back
on.
9. Turn power OFF and switch MODE SELECTOR to RUN and turn power ON.
10. The BAUD RATE switch and MEMORY SELECTOR should be facing upwards.
11. You have now finished downloading the new program.
PLC EPROM INSTALLATION INSTRUCTIONS
For TOUCH SCREEN Version T-1000
1. Complete steps 1-9.
2. Turn power OFF.
3. The BAUD RATE switch should be facing DOWN, and the MEMORY SELECTOR switch
should be UP.
4. Turn power ON.
5. You have now now finished downloading the new program.
73
To Next Page
Loading...
