Advanced Poly-Packaging T-1000 - 6.3 Scheduled Maintenance Chart

6.3 Scheduled Maintenance Chart
CHART
ITEM DESCRIPTION 12345678910
INITIALS
OOOOOOOOOOInspect for wear, cuts, leaking,
replace as required
Air lines &
connectors
OOOOOOOOOOInspect for contamination,
replace as necessary
Air (blower)
filter
OOOOOOOOOOListen for air leakage, replace
or repair as required
Main Seal
Cylinder
OOOOOOOOOOBlow off with clean, dry air,
inspect for loose wires,
connectors
Printed circuit
boards
OOOOOOOOOOClean w/ alcohol, inspect for
burs
Lower aluminum
roller
OOOOOOOOOInspect for cuts, unevennessUpper rubber roll
OOOO OInspect for wear, replace when
necessary
Perf sensor &
spring
OOOOOOOOOOInspect for free movementRoller bearings
OOOOOOOOOOInspect for free movementGuide rollers
OO OO ODisassemble, clean, inspect
springs for wear, breakage
(frequency dependent on
environment and product)
Pressure bar
assembly
OOOOOOOOOOInspect for fraying, cuts,
loose connections
Heater element &
wiring
OOOOOOOOOOInspect for wear, replace when
necessary
Drive belt
(left panel)
OOOOOOOOOOAdjust/Inspect for wear
replace when necessary
Drive belt
(right panel)
(Note: Each chart change represents 1MM cycles)
129