DS-980/DS-980GL User Manual 18
3.3 DDR4 SO-DIMM Memory Installation
1. Respectively remove 4 screws with number 1 and 2 six-angle screws with num-
ber 2 at the back of the plate.
2. Push DS-980/DS-980GL top case (number 3) back, then remove it.
3. Install DDR4 SO-DIMM memory into the appropriate SO-DIMM slots.
4. After completed it, please push DS-980/DS-980GL top case (number 3) towards
the front side and exactly cover the system. Then, tighten all the screws (num-
ber 1 & 2) back on the chassis.
Figure 3.2 DDR4 SO-DIMM memory installation
To Next Page
Loading...
