• Verify that the “SYNC“ LED beneath the “CALL“ button corresponding to that channel is
lighted in green to indicate that the communication has been successfully established.
• Press the “ON AIR“ button to allow the transmission of full-duplex audio for that
channel.
• Send audio from one equipment to another verifying that the “Tx” and “Rx” audio
presence indicators change to green.
• If necessary, adjust the output levels in the “att” box at OUTPUTS block in
“Configuration” ”General” screen. You can also make an additional adjustment from
the windows you access by pressing “In gain” button in “ENCODER” green window and
“Out gain” button in “DECODER” green window.
To Next Page
Loading...
Need help?
General