12. Wait for on-screen confirmation that the operation has been successfully completed.
13. In the Internet browser, go to the UPGRADE section and ensure that all the firmware
versions installed in your codec are now the correct ones.
14. Power the unit down.
7.2. Configuring the MAC address associated with the Ethernet interface.
From this menu the MAC address associated with the Ethernet interface can be edited;
because of the consequences this action could have, the addresses should only be edited if the
codec use situation requires it. The editing should be performed by highly qualified personnel or
under the supervision of AEQ authorized technical services, and always in possession of the
required network information.
1. From MAIN STATUS
SYSTEM
8-SETTINGS
ETHERNET SETTINGS
ETHERNET CONFIG, check the IP address associated with the Ethernet interface.
2. Power down the PHOENIX STRATOS.
3. Connect PHOENIX STRATOS to the PC from which you are going to perform the
upgrading process using a crossed cable.
4. Power up the PHOENIX STRATOS.
5. Open the Internet Explorer web browser and, in the address bar, enter HTTP://<IP
address obtained in point 1>. Press ENTER and the main screen will be displayed.
Selecting the MAINTENANCE option will enable you to modify the MAC address of the
Ethernet interface of the unit.
MAC change screen detail
6. Modify the value in the MAC field associated with the desired Ethernet interface.
7. Press the “Apply” button.
8. Wait for on-screen confirmation that the operation has been successfully completed.
9. In the Internet browser, go to the MAINTENANCE section and ensure that the MAC
addresses are now the correct ones.
10. Power the unit down.
7.3. Technical Assistance Service and on-line manuals.
Clicking on the “Support” tab in the upper part of the screen will take you to AEQ website,
where you will find all the information you need to directly contact the AEQ Technical
Assistance Service, as well as all the technical information and manuals regarding the unit.
To Next Page
Loading...
Need help?
General