o CONNECTED.
• Verify that the SYNC LED beneath the CALL button is lighted in green to indicate that
the communication has been successfully established.
• Press the ON AIR button associated with that communications channel to enable audio
to be transmitted over that interface in full duplex mode.
• Once the connection has been established with the remote end, confirm the presence
of transmitted and received audio by checking the VU meters on the Phoenix
STRATOS front panel.
o If necessary, adjust the levels in AUDIO SETTINGS
CODEC CHANNEL1
SETTINGS (or CODEC CHANNEL2 SETTINGS) menu or in ANALOG AUDIO
SETTINGS menu, according to the desired signal type.
The automatic answering mode can be activated or deactivated in the MENU SYSTEM
6-
CHANNELS
Chn1 or Chn2
AUTOANSWER.
To Next Page
Loading...
Need help?
General