• Return to the individual codec control window and click on
“CALL“ button corresponding to that channel, showing then the
call screen:
Enter the IP address of the remote unit, either
manually or getting it from the buttons:
By clicking here, the last completed calls (“Calls”) the contacts stored in the call book
(“Eq. Contacts”) or the reachable IP units (“Quick Dest.”) are shown respectively, but
only those configured with formats compatible with channel and communication type.
• It is mandatory that the called unit URI is specified in any of the following formats,
adequate for Proxy SIP communications:
o <equipment’s_name>, for example: “phstr_231” or “phoenixMaster”
o <equipment’s_name>@<SIP_realm>, for example:
“phstr_231@sip.aeq.es” or phoenixMaster@sip.aeq.es”
o <equipment’s_name>@<SIP_server_IP>, for example:
“phstr_231@232.168.1.2” or “phoenixMaster@232.168.1.2” (where 232.168.1.2.
is AEQ SIP Server (“sip.aeq.es”) IP address )
o <equipment’s_name>@<SIP_server>:<Port>, when SIP port is not 5060 (the
one used by default in SIP SERVER mode). For example:
“
phstr_231@sip.aeq.es:5061”
VERY IMPORTANT: <equipment’s_name> must not be longer than 19 characters.
To Next Page
Loading...