INSPY. 1003. 4138305_03
45
FOR THE INSTALLER
17. SELECTION AND PLACE OF
INSTALLATION
Before installing the unit, decide with
the customer the position in which it will
be placed, pay attention to the follow-
ing points:
− the support surface must be able to
withstand the weight of the unit;
− the safety distance between the
units and other equipment or struc-
tures must be strictly respected so
that the air in fans inlet and outlet
circulates freely.
− The unit must be installed by an
authorised technician in compli-
ance with the national laws in the
country of destination respecting
the minimum technical spaces to
allow maintenance.
18. POSITIONING
The machine is delivered from the fac-
tory wrapped in estincoil.
Before moving the unit, check the lifting
capacity of the machines used.
Once the packaging has been re-
moved, the unit must be handled by
qualified personnel with the suitable
equipment. To handle the machine:
see figure
− hook up the lifting belts to the
provided eyebolts (as indicated in
figure).
WARNING: ALWAYS USE ALL THE
PROVIDED EYEBOLTS
− In order to avoid damaging the unit
with the cables, insert protection
elements between them and the
machine. It is absolutely forbidden
to stand beneath the unit.
− Take into account that when the
chiller is working, vibrations may be
generated; it is therefore advisable
to install anti-vibration supports (AVX
accessories), fitting them to the holes
in the base according to the assembly
diagram.
−
It is compulsory to provide the
necessary technical spaces, to al-
low REGULAR AND EXTRAORDINARY
MAINTENANCE INTERVENTIONS
− Fasten the unit by checking careful-
ly that its on the same level; check
that easy access to the hydraulic
and electric part is allowed.
18.1. MINIMUM TECHNICAL SPACES (mm)
3000
height
WARNING: AL-
WAYS USE ALL
THE PROVIDED
EYEBOLTS
The unit must be installed by an authorised and qualified technician, in
compliance with the national legislation in force in the country of destination
(MD 329/2004).
We shall not be held responsible for any damage whatsoever resulting from
the non-compliance with these instructions.
Before starting any kind of work, it is necessary TO READ CAREFULLY THE IN-
STRUCTIONS, AND TO PERFORM THE SAFETY CHECKS TO REDUCE ANY RISK TO A
MINIMUM. All the personnel in charge must know the operations and possible
risks that may arise when all the unit installation operations begin.
1100
800
800
800
To Next Page
Loading...
Need help?
General
