AERMEC 2002 User Manual

INSPY. 1003. 4138305_03
80
WARNING:
The high efficiency unit
6003 - 6303
- 6303 - 6903 - 7203 A - E
For space reasons they are sent sepa-
rately for the position of the vibration
dampers and the water connections
refer to their composition.
At the site, you must:
1. Placement of the two units
with possible alignment that
should be done by acting on
the cylinder of the AVX in
1/2 mm order
2. Connect electronically the elec-
trical panel of the first unit with
the right place of the last unit
3. Hydraulically connect the units.
Double and triple module
models, the water outlet
probe (WOP), with its trap,
is free, next to the electrical
box, remember to insert it
in the collector of the outlet
hydraulic parallel, providing
a first sleeve ½ inch.
4.
NB THE INSTALLER IS RESPONSIBLE
FOR THE HYDRAULIC PARALLEL.
for further information on the
installation, refer to the specific
chapter (HYDRAULIC CIRCUITS -
ELECTRICAL WIRINGS...)
SWITCH
MAIN
IG
SUPPLY
EARTH
SUPPLY
EARTH
is free, next to the electrical
box
,
remember to insert it
in the collector of the outlet
hydraulic parallel, providing
a first sleeve
½
inch.
THE IN
S
TALLER
IS
RESPONSIBLE
S
R
THE HYDRAULI
C
PARALLEL.
further information on the
t
allation, refer to the specif
ic
apter (
H
YDRAULI
C
C
IR
C
UIT
S
-
(
(
E
CTRICAL WIRINGS...
)
SWITCH
SUPPLY
EARTH
SUPPLY
EARTH
NS 6003 A/E
formato da:
NS 1801 A/E
NS 1801 A/E
NS 2401 A/E
NS 6303 A/E
formato da:
NS 1801 A/E
NS 2101 A/E
NS 2401 A/E
NS 6603 A/E
formato da:
NS 1801 A/E
NS 2401 A/E
NS 2401 A/E
NS 6903 A/E
formato da:
NS 2101 A/E
NS 2401 A/E
NS 2401 A/E
NS 7203 A/E
formato da:
NS 2401 A/E
NS 2401 A/E
NS 2401 A/E

AERMEC 2002 Specifications

General

Brand	AERMEC
Model	2002
Category	Chiller
Language	English