AERMEC MODUCONTROL Usage Manual

48
GB
6343841_00 / Ver - 4.20
USER menu
To access the USER menu, press the
key in (Fig.7). Once the key has been
pressed, you must insert the password
to access the various menus; to access
the user menu, the password is 000 (di-
splayed by default). To modify the value
of the passwords, use the arrow keys.
When you have inserted the correct
password, press the key in (Fig.7). The
monitor will show the index of the USER
parameter and a 3-character string that
identifi es it; the string will be displayed
for one second, after which it is repla-
ced by the value of the parameter itself.
To move on to the next parameter, use
the arrow keys (Fig.8). To modify a pa-
rameter, just select it, press the key in
(Fig.7), modify the assigned value using
the arrow keys in (Fig.8), and confi rm
the modifi cation by pressing the key in
(Fig.7) again.
R
Fig.7 Fig.8
R
Setting operational parameters (user level)
PASSWORD = 000
Setting of operational mode (HOT/COLD)
Index - String
MIN
value
MAX
value
Parameter function
j
j
01
This parameter identifies the functioning mode set for the unit:
• set value = 0 - Cooling mode;
• set value = 1 - Heating mode.
In cooling only units, this parameter is displayed but it cannot be modified.
In software versions prior to 3.75, to make the season change the unit must be in
standby.
Setting of cooling temperature
Index - String
MIN
value
MAX
value
Parameter function
-20°C 26°C This parameter indicates the value of the work setting active in cooling mode.
j
j
j
Parameters only visible in heat pump models
j
j
j
Parameters only visible in models set for
hot domestic water production
Parameters only visible in the models with DCP installed
Parameters only visible in bicompressor models
Parameters only visible in the models with inverter compressor

AERMEC MODUCONTROL Specifications

General

Brand	AERMEC
Model	MODUCONTROL
Category	Control Unit
Language	English