AERMEC MODUCONTROL Usage Manual

61
GB
6343841_00 / Ver - 4.20
Setting supplementary electric heater setpoint
Index - String
MIN
value
MAX
value
Parameter function
jj
0°C 65°C
This parameter indicates the deviation from the heating setpoint, for switching off the
electric heater (if active) in supplementary mode; as shown in Fig.12 on the previous page
(Parameter Sri).
Setting electric heater band in supplementary/replacement mode
Index - String
MIN
value
MAX
value
Parameter function
jj
0°C 20°C
In supplementary mode, the temperature of the water in the system is checked before
the unit is switched on. If the temperature is less than/equal to the value calculated for
the switch-on band, the electric heater will be switched on and will operate as per the
diagram on the previous page Fig.12. The value of the switch-on band is calculated as
follows: switch-on band = (Heating setpoint) - (Parameter Sri) - (Parameter Bri); see Fig.12
on previous page;
In replacement mode, this parameter represents the band of deviation from the heating
setpoint, within which the heater will be activated or deactivated, as shown on the pre-
vious page Fig.13.
Setting outside air temperature threshold for supplementary mode
Index - String
MIN
value
MAX
value
Parameter function
jj
-40°C 50°C
This parameter indicates the outside air temperature threshold, beneath which the
heater is activated in supplementary mode; as shown on the previous page, in Fig.11
Parameter tA1.
Setting outside air temperature threshold for replacement mode
Index - String
MIN
value
MAX
value
Parameter function
jj
-40°C 50°C
This parameter indicates the outside air temperature threshold, beneath which the
heater is activated in replacement mode; as shown on the previous page, in [Fig.A]
Parameter tA2.
Setting the band for air temperature
Index - String
MIN
value
MAX
value
Parameter function
jj
0°C 20°C This parameter indicates the band applied to the air temperature setpoints (tA1-tA2).
j
j
j
Parameters only visible in heat pump models
j
j
j
Parameters only visible in models set for
hot domestic water production
Parameters only visible in the models with DCP installed
Parameters only visible in bicompressor models
Parameters only visible in the models with inverter compressor

AERMEC MODUCONTROL Specifications

General

Brand	AERMEC
Model	MODUCONTROL
Category	Control Unit
Language	English