AERMEC TRS Series - Identification of the Unit; Introduction; Technical Features

42
TRS
24/07 5979398_00
2 IDENTIFICATION OF THE UNIT
Identication EC
The recovery units are CE marked according As dictated by the European
Community, with Directives 2006/42 / EC, 2004/108 / EC, 2006/95 / EC,
2002/95 / EC, 2002/96 / EC, as modications.
IMPORTANT NOTES: THE HEAT RECOVERY UNITS OF TRS SERIES ARE ONLY SUITABLE FOR INTERNAL INSTAL-
LATION.
The heat recovery unit is a machine designed and built exclusively to change air in the civil environments, incompatible with
toxic and inammable gases. Therefore it cannot be used in those environments where the air is mixed and/or altered by
other gaseous composites and/or solid particles.
The use of the same for dierent purposes from those envisioned, not conform to that described in this manual, will make
any direct and/or indirect liability of the Manufacturer automatically become null and void.
2.1 INTRODUCTION
The TRS heat recovery units feature compact dimensions and easy assembly.
The TRS heat recovery units combine maximum room comfort with certain energy savings.
Current air-conditioning and air handling systems require forced ventilation, which consequently involves the discharge of
the conditioned air and as a result means signicant energy consumption and an increase in running costs.
The TRS series has been designed to resolve these probles by the use of static exchangers. The TRS series adopts an heat
recovery made of plane sheets of special paper. The drain pan collector is not present because the humidity contained in
one of air ows is partially absorbed by the porous surface but then completely transferred to the opposite ow: therefore
the humidity condensation is avoided. The high static pressure values available allow the use of ducting for the extraction
or distribution of air in a series of rooms.
2.2 TECHNICAL FEATURES
— Air-to-air enthalpy heat recovery device, thermal eciency up to 76%.
— Galvanized steel self-supporting panels, internally and externally insulated; accessibility from side door.
— Air ltering in eciency class ISO16890 ePM
2,5
95% (F9 EN 779) with COARSE 50% pre-lter (G3 EN 779) on fresh air and
COARSE 50% lter on recovery ow.
— Integrated pressure switch for dirty lter signal.
— Integrated pressure switch for dirty lter signal Motorised heat recovery by-pass device, automatically controlled by unit
control to use fresh air free-cooling when convenient.
— Low consumption high eciency & low noise direct driven fans with 10-speed EC motors.
— Connections to funnels with plastic ttings
— Built-in electrical panel with electronic board for controlling the ventilation and free-cooling functions and oering an
interface via the Modbus protocol for supervising the operating parameters.