AERMEC TRS Series - Installation and Start-Up; Preliminary Information; Safety Standards

48
TRS
24/07 5979398_00
7 INSTALLATION AND STARTUP
Denitions:
— CUSTOMER: The customer is the person, the agency or the company who bought or rented the unit.
— USER / OPERATOR - The operator or user is the physical person who uses the unit for the purpose for which it was
designed.
— SPECIALISTIC STAFF - It is composed by the physical trained persons, able to recognize any danger due to the
proper and improper use of the unit and able to avoid or repair it. inammable or toxic gases at a high temper-
ature.
7.1 SAFETY STANDARDS
THE MANUFACTURER DECLINES ALL RESPONSIBILITY FOR THE FAILURE TO COMPLY WITH THE SAFETY AND
ACCIDENT PRE-VENTION STANDARDS DESCRIBED BELOW. IT ALSO DECLINES ALL LIABILITY FOR DAMAGE
CAUSED BY IMPROPER USE OF THE UNIT AND/OR MODIFICATIONS PERFOR-MED WITHOUT AUTHORISA-
TION. SPECIALISED STAFF MUST PERFORM INSTALLATION.
— Wear suitable and accident-prevention clothing during installation, for example: goggles, gloves etc. as indicated in the
cu rent regulation.
— During installation operate in complete safety, clean environment and free from obstructions.
— Respect the laws in force, in the country in which the machine is installed, relative to use and disposal of packaging and
the products used for cleaning and maintenance of the machine, as well as complying with that recommended by the
producer of these products.
— Before starting the unit, check the perfect integrity of the various components of the entire system.
— Do not touch moving parts or intervene between these.
— Do not perform maintenance and cleaning until the electric line has been connected.
— The maintenance and replacement of damaged or worn parts must only be performed by specialised sta and following
the indications given in this manual.
— The spare parts must correspond to the requirements dened by the manufacturer.
— If the unit must be dismantled, follow the envisioned anti-pollution standards.
 Note: When using the unit, the installer and user must consider and solve all risks connected to the plant. For example, risks
deriving from the entry of foreign bodies or risks due to the conveying of dangerous inammable or toxic gases at a high
temperature.
7.2 PRELIMINARY INFORMATION
— Operate in compliance with the safety regulations in force, ensuring sucient freedom of movement and cleanliness of
the installation environments.
— Wear protective clothing and personal protective equipment (glasses, gloves, etc.)
— Transport the packed section as close as possible to the place of installation
— Don’t place tools or other jobsite equipment over the packed unit
— Don’t use the unit as a store of yard tools
— Don’t touch moving parts and don’t use them as supports
— Check the full integrity of all unit components.