47
TRS
24/07 5979398_00
6 CHECKS BEFORE SHIPMENT
All the units, before being sent, undergo a series of checks, as listed below:
— Visual inspection of the nishes
— Checks to ensure all the components are integral
— Electrical safety checks
— Functional test on the electric fans
— Application of the identication plates.
6.1 TRANSPORT
— The air handling units are packed in cardboard boxes that must remain intact until assembly.
— The components that, due to technical, constructional, transport or other requirements are not tted on the unit, but
sent separately either inside the unit or otherwise, are specially protected and duly described on the packing list.
— No other material must be stacked on the products: the manufacturer declines all liability in the event of damage deriv-
ing from such loads.
THE FASTENING OF THE LOAD ON THE TRUCK IS THE RESPONSIBILITY OF THE CARRIER, AND MUST BE PER-
FORMED, USING STRAPS OR ROPES, SO AS TO AVOID DAMAGING THE PACKAGING.
6.2 DRAINAGE
Inspection upon receipt
When receiving the goods, before unloading, all the material delivered must be checked to ascertain the presence of any
damage caused during transport. Any damage found must be reported to the carrier, accepting the goods with reservation
and specifying the type of damage on the delivery documents.
Hoisting and Handling
It is strongly recommended:
WHEN HANDLING THE UNITS, USE SUITABLE MEANS ACCORDING THE WEIGHTS INVOLVED, AS ENVISAGED
BY EC DIRECTIVE 89/391 AND SUBSEQUENT AMENDMENTS
— The weight of the units is shown on this manual.
— Avoid uncontrolled rotations.
— Place the goods down with care, avoiding sudden movements or, worse, dropping the goods.
Storage
In the event of extended storage before installation, keep the units protected from dust and bad weather and away from
sources of vibrations and heat.
THE MANUFACTURER DECLINES ALL LIABILITY FOR DAMAGE DERIVING FROM INCORRECT UNLOADING OR
INADEQUATE PROTECTION OF THE UNITS AGAINST THE ELEMENTS.
To Next Page
Loading...
