• Activation: The battery can only be used after being put in the drone,
connected to the app and then activated as prompted.
• Power Level: The 4 indicator lights indicate the approximate percentage of
battery power left. The app will show the precise battery power remaining.
• AI Learning: The battery will intelligently adjust its power output levels over
time based on temperature, altitude, and normal payload, to maximise flight
time and performance for your unique conditions.
• Firmware Update: The battery firmware may occasionally require an update if
prompted in the App. The outer two indicator lights being solid on indicates
the battery is updating. Do not use the battery during the update.
• Balanced Charging: During charging, the voltages of the 6 battery cells are
automatically balanced by the smart charger and onboard battery AI system.
• Overcurrent Protection: The battery stops charging or discharging
automatically once fullly charged.
• Smart Discharge: The batteries’ AI management system will intelligently
discharge the battery at varied rates over time to maximise storage life.
• Short Circuit Protection: The power supply will automatically cut out if a short
circuit is detected, to protect the batteries.
• Battery Cell Damage Protection: The app will display a warning message
when a damaged battery cell is detected. This can be caused by overloading
the drone, leaving the battery discharged, etc.
• Hibernation Mode: The battery will automatically power off after 3 minutes if
it is not connected to the aircraft. If the power is less than 1%, the minimum
power indicator will flash (after pressing the power button) and the battery
cannot be turned on, to wake the battery, fully re-charge it to 100%.
• Data Log: Information about the battery's voltage, capacity, and current is
transmitted to the aircraft and can be seen in the flight logs.
• Low temperature heating: In extreme environments (as low as -10°C), the
battery (if over 30%) will intelligently heat the internal cells and adjust power
output to the climate. In extreme conditions, allow the aircraft to idle for 2-5
minutes after starting up to allow time for the battery to heat up to the
optimal temperature range. To maximise battery life, place the battery on
charge instead of inside the aircraft to heat up before flight.
2.2.3 AI Flight Battery Functions
10
To Next Page