3.4 Charging The Remote Controller Battery
The Remote Control uses a USB-C cable to charge, as shown below:
The Remote Controller charging time is
approx. 120 minutes. The battery
indicator light flashes sequentially during
charging. When charging is complete, all
4 lights will stay on solid.
The charging current is 2A, you can use
any USB outlet or the charging station to
charge.
• Adjust the remote control antenna to be perpendicular (flat side) facing
the aircraft at all times.
• Separate both antennas to maximise range and signal strength.
• Do not cross or direct antennas toward each other.
3.5 Remote Control Antenna Angle
Best for long
range signal
Strongest short
range signal
Avoid
25
To Next Page