FAQ
How do I connect my phone and the remote control?
1. Please ensure the remote and phone are connected correctly using the
supplied RC Cable.
2. Ensure the aircraft and remote are powered on.
3. Clean out your phone's charging port carefully (can use a pin/toothpick/
blu-tak) to ensure a better connection.
4. Switch your phone to airplane mode, and restart if necessary.
5. If it is still not connecting, please try using another cable, or email us at
support@aeroodrones.com.
How do I fly without my phone connected?
1. Power on the remote control.
2. Power on the aircraft.
3. Allow up to 5 minutes for the aircraft to acquire satellites and become ready
to fly.
4. Once it is ready to fly (there are no indicator lights), you will be able to unlock
the motors by holding both joysticks down and out to the sides.
5. If it is not starting up, it may need a compass calibration - in which case you
will need to connect your mobile device.
Firmware update is failing/slow?
1. Please allow up to 1hr for the update to complete (will vary by device type).
2. It is common for the update to be stuck on a certain percentage, please allow
time for it to process.
3. The aircraft may beep or turn off during the update. Please disregard and
follow on-screen prompts.
How do I setup for drone fishing?
Please refer to the “Fishing” section of the Manual, or check out our fishing page to
safely get setup for drone fishing: https://aeroodrones.com/blogs/fishing
48
To Next Page