How do I turn on the bottom landing light?
Go to Settings > Aircraft > “Auxiliary light” and select your preferred mode, the aircraft
must be flying for the light to come on.
Payload Release is not working?
Ensure you are pressing the button for a short press ~0.5s (not long or too short)
Ensure you are using a resistance-free drop loop and your payload is less than 1kg.
Test the release over land with varied payloads to check function.
Battery is not charging?
The charging station holds up to 4 batteries, but will only charge one at a time.
After placing a battery on charge, it will take a few seconds to begin charging.
How do I increase the range?
1. Ensure the environment is clear and away from any sources of interference,
including other RC toys, buildings, metal objects or radio towers etc.
2. Turn your mobile device to airplane mode and disable Wi-Fi and Bluetooth.
3. Face the aircraft at all times and keep it within clear line of sight.
4. Point the remote antennas to always be perpendicular (flat side) to the aircraft.
The drone is flying in circles or not flying straight?
1. Re-calibrate the compass.
2. Perform a gyro calibration on a flat surface.
3. Ensure you have GPS acquired and are in a clear area away from any interference.
4. Allow the aircraft to hover for ~30 seconds after taking off.
RTH is inaccurate?
First, ensure “AI Search for landing pad” is turned ON, and you are using the correct pad.
The RTH accuracy is determined based on how many satellites are acquired before
takeoff. To improve accuracy, allow the aircraft to sit for a few minutes after showing
“Ready to Fly” to acquire more satellites. Always take-off in a safe, wide, open space.
Gimbal Error?
1. Restart the aircraft.
2. Visit: Settings > Gimbal > Advanced Settings, and perform the Gimbal calibration.
49
To Next Page