Afag CS 8/10-SD - Table of Contents

Table of contents
Assembly instructions EN  CS 8 - CS 12  Date 01.06.2021  Version 4.5 3–56
Table of contents
1 General .................................................................................................................... 6
Contents and purpose of these assembly instructions ................................. 6
Explanation of symbols................................................................................. 6
Additional symbols ........................................................................................ 7
Applicable documents .................................................................................. 8
Warranty ....................................................................................................... 8
Liability .......................................................................................................... 8
2 Safety instructions ................................................................................................. 9
General ......................................................................................................... 9
Intended use ................................................................................................. 9
Foreseeable misuse ..................................................................................... 9
Obligations of the operator and the personnel ........................................... 10
2.4.1 Observe the assembly instructions ...................................................... 10
2.4.2 Obligations of the operating company.................................................. 10
2.4.3 Obligations of the personnel ................................................................ 11
Personnel requirements ............................................................................. 11
2.5.1 Personnel qualification ......................................................................... 11
Personal protective equipment (PPE) ........................................................ 12
Changes and modifications ........................................................................ 12
General hazards / residual risks ................................................................. 13
2.8.1 General hazards at the workplace ....................................................... 13
2.8.2 Danger due to electricity ...................................................................... 14
2.8.3 Mechanical hazards ............................................................................. 14
2.8.4 Danger due to pneumatics ................................................................... 15
2.8.5 Danger caused by omitting maintenance work .................................... 15
3 Technical data ...................................................................................................... 16
Compact slide CS 8 .................................................................................... 16
3.1.1 Dimensional drawing CS 8 ................................................................... 16
3.1.2 Technical data CS 8 ............................................................................. 17
3.1.3 Preferred combinations CS 8 ............................................................... 18
3.1.4 Slide loads CS 8 ................................................................................... 19
3.1.5 Operation time diagram CS 8 ............................................................... 20
Compact slide CS 12 .................................................................................. 21
3.2.1 Dimensional drawing CS 12 ................................................................. 21
3.2.2 Technical data CS 12 ........................................................................... 22
3.2.3 Preferred combinations CS 12 ............................................................. 23
3.2.4 Slide loads CS 12 ................................................................................. 24
3.2.5 Operation time diagram CS 12 ............................................................. 25
4 Transport, packaging and storage ..................................................................... 26