Declaration of incorporation
Assembly instructions EN CS 8 - CS 12 Date 01.06.2021 Version 4.5 51–56
11 Declaration of incorporation
Declaration of incorporation
for partly completed machinery according to the
Machinery Directive 2006/42/EC, Annex II, 1.B
The manufacturer hereby declares:
Afag Automation AG, Luzernstrasse 32, CH-6144 Zell
that the partly completed machine:
Product description Compact Slide (pneumatic)
Type: CS 8, CS 12
Consecutive serial no. 50XXXXXX
complies with the following essential health and safety requirements of the Machinery Directive 2006/42/EC
at the time of declaration: 1.1; 1.1.1; 1.1.2; 1.2.3; 1.3.3; 1.3.6; 1.3.7.1.4.1; 1.5; 1.6; 1.6.1; 1.6.2; 1.6.4; 1.7;
1.7.4; 1.7.4.2.
Harmonised standards applied, in particular:
EN ISO 12100:2010 Safety of machinery - General principles for design - Risk assessment and
risk reduction.
Note: The partly completed machinery must not be put into service until the machinery into which it is to
be incorporated has been declared in conformity with the provisions of Machinery Directive
2006/42/EC.
The manufacturer undertakes to transmit, in response to a reasoned request by the national authorities,
relevant technical documentation for the partly completed machinery.
The relevant technical documentation was created according to Annex VII, Part B of the above-mentioned
Directive.
Authorised representative for compiling the technical documentation:
Niklaus Röthlisberger, Product Manager, Afag Automation AG, CH-6144 Zell
Place/Date: Zell, 15.06.2021
Siegfried Egli
Managing Director
Niklaus Röthlisberger
Product Manager
To Next Page
Loading...
