AGFA CR 10-X - Cleaning and Disinfection; Cleaning the cassette adapter

Cleaning and Disinfection
All appropriate policies and procedures should be followed to avoid
contamination of the staff, patients and device. All existing universal
precautions should be taken to avoid that the digitizer and its accessories
come into contact with potential contaminations. Details about cleaning can
be found in the following pages.
To clean the exterior of the digitizer:
1. Switch off the digitizer.
2. Remove the power plug from the socket.
CAUTION:
Damage or deterioration of safety provisions can cause
injury of the operator.
Remove the power plug from the socket before cleaning the
exterior of the device.
Switch off the UPS, if installed.
3. Wipe the exterior of the digitizer with a clean, soft, damp cloth.
Use a mild soap or detergent if required but never use ammonia-based
cleaner.
CAUTION:
Make sure no liquid gets in the digitizer.
Note: Do not open the digitizer for cleaning. No components
inside the digitizer require cleaning by the user.
4. Plug the power plug into the socket.
Switch on the UPS, if installed.
Cleaning the cassette adapter
To clean the cassette adapter:
Wipe the cassette adapter with a clean, soft, damp cloth. Use a mild soap
or detergent if required but never use ammonia-based cleaner.
CR 10-X, CR 12-X, CR 15-X | Introduction | 29
2491E EN 20150409 1543