AGFA CR 10-X - Maintenance; Preventive Maintenance; Cleaning the Optical Unit

Maintenance
Topics:
• Preventive Maintenance
• Cleaning the Optical Unit
Preventive Maintenance
No regular preventive maintenance is required other than described further in
this chapter.
The digitizer informs you when preventive maintenance is required and
displays the following message "Maintenance interval expired. Please contact
service."
Preventive maintenance should be performed by an Agfa certified service
engineer.
Cleaning the Optical Unit
CAUTION:
Dust can cause stripes in the image, parallel to the image
plate movement.
When you recognize this type of artefact, clean the optic unit
using the cleaning brush.
Related Links
Cleaning the Optical Unit on page 71
CR 10-X, CR 12-X, CR 15-X | Introduction | 31
2491E EN 20150409 1543