• Do not allow the digitizer to be subject to excessive vibration during
operation, due to unstable ground (e.g. vibration of nearby equipment or
footsteps).
• Switch off the device before performing any maintenance work or repairs.
Disconnect the digitizer from the mains before making repairs or
performing any maintenance activities during which live electrical
components may be exposed.
• As is the case for all technical devices, the digitizer must be operated,
cared for and serviced correctly. A regular quality control is
recommended.
• If you do not operate the digitizer correctly or if you do not have it
serviced correctly, Agfa is not liable for resulting disturbances, damages or
injuries.
• If you notice conspicuous noise or smoke, disconnect the digitizer
immediately.
• Do not pour water or any other liquid over the device.
• Switch the system off before moving it. When reaching the new position,
switch the system on again.
• Do not transport the digitizer without packaging or without mounting it in
a mobile kit.
36 | CR 10-X, CR 12-X, CR 15-X | Introduction
2491E EN 20150409 1543
To Next Page
Loading...
