4. As soon as the digitizer has received the complete identification data from
the NX station (via Ethernet) it will start digitizing the image plate.
The digitizer converts the information of the latent image to digital data.
5. After digitizing, the digitizer:
• Transmits the digital image data to the image processing station
(‘destination’).
• Erases the image plate and re-inserts it into the cassette.
• The status indicator constantly lights up in green and the cassette can
be unlocked.
6. Push the Cassette release button and remove the cassette from the cassette
slot.
CAUTION:
Pushing the release button during scanning or during
erasure stops operation immediately and can cause an
image being lost, a need to retake the image or delayed
diagnosis.
Do not push the release button during scanning (status
indicator is blinking yellow) or during erasure (status
indicator blue).
44 | CR 10-X, CR 12-X, CR 15-X | Getting started
2491E EN 20150409 1543
To Next Page
Loading...
