AGFA CR 85-X Reference Manual

29
4451C EN 2013-04-30 Introducing the CR 85-X
CR 85-X DIGITIZER
If the system has been idle for 5 minutes, the backlit LCD display dims. The
display lightens if:
• The display message changes, e.g. if the Digitizer receives a message from
the image processing station.
• You place a cassette in the input buffer.
• You press a key on the keypad.
 In key-operator mode, operation is menu driven. The menu displays the key-
operator functions, the active keys, and the service code.
1
Set-up of image processing station:
• [blank]: Default image processing station selected.
• Off line: Transmission to all image processing stations disabled.
• [process.station] not ready: Image processing station not available.
• [process.station] rerouted: Images rerouted to other image processing station.
2
Type of message
3
Extra comment or action to take
4
System status:
• READY: The CR 85-X is ready for operation.
• BUSY: The CR 85-X is busy with scanning or erasing.
• ERROR: An error has occurred. Refer to Chapter 4, ‘Troubleshooting’.
•LOCKED: id.
•WARNING: id.
5
Operation mode:
• [blank]: Normal operation mode.
• EMERGENCY: Emergency function for image plates with ID data.
• ERASURE: Re-erasure function.
6
Error status: service code (SERVICE XXXXX) or error code (CODE XXXXX)
7
Station name of the CR 85-X
Identifier of image plate being treated:
8.1
8.2
8.3
After image ID data is read;
During scanning of image plate and transmittal of image data;
During transmittal of image data to image processing station.

AGFA CR 85-X Specifications

General

Brand	AGFA
Model	CR 85-X
Category	Measuring Instruments
Language	English