DR Detector is not switched to standby or switched off
automatically
Details The DR detector is configured to switch to standby (sleep) or to
switch off after not being used for a specific time, but it stays ac-
tive.
Cause In following conditions, the DR detector will not be switched to
standby or be switched off automatically:
• On the NX workstation an empty thumbnail is selected for an
exposure on the DR detector
• The NX software is not running
• The DR detector is out of range of the wireless network
• The DR detector is being calibrated
• The DR detector is in error
Brief
Solution
Make sure none of the above conditions apply.
112 | DR 10e, DR 14e, DR 17e | Problem solving
0370C EN 20200228 1449
To Next Page
Loading...
