Automatically turning the DR Detector to sleep
The DR Detector can be configured to switch to standby (sleep) automatically
after not being used for a specific time.
The power indicator and the battery status indicator remain on.
New exposures can be made. After selecting an exposure on the NX
workstation, there will be a short delay until the DR Detector becomes ready
for exposure.
Automatically turning off DR Detector
The DR Detector can be configured to switch off automatically after not being
used for a specific time.
The power indicator remains on. The battery status indicator is off.
For making new exposures, the DR Detector must be started again by
removing the battery and inserting it again.
94 | DR 10e, DR 14e, DR 17e | Getting started
0370C EN 20200228 1449
To Next Page
Loading...
