Stopping the DR Detector (wired configuration)
The DR Detector is connected to the DR Detector power box. No battery is
attached to the DR Detector.
To stop the DR Detector:
1. Disconnect the DR Detector cable.
Press and hold the latches on both sides of the connector.
Pull the connector of the cable straight out of the connector slot of the DR
Detector.
2. Unplug the power cable of the DR Detector power box.
Note: When not in use, keep the detector, handle unit with grid in a
designated location or in a location where they are safe and cannot
fall down.
DR 10e, DR 14e, DR 17e | Getting started | 95
0370C EN 20200228 1449
To Next Page
Loading...
