AGFA DR 10e - Attaching the Handle Unit with Grid

Attaching the Handle Unit with Grid
1
2
CAUTION:
To safely attach the handle unit for making exposures using the
grid, follow these instructions.
1. Lay down the grid on a flat surface.
2. Lay the DR Detector in the grid, bottom edge first, with the tube side
facing down (1).
3. Attach the grid to the DR Detector (2).
WARNING:
Use only the grid that is supplied as option to the DR
Detector.
98 | DR 10e, DR 14e, DR 17e | Attaching the Handle Unit with Grid
0370C EN 20200228 1449