AgfaPhoto SELECTA 16 - Connecting the Camera and Printer

72 73
AgfaPhoto SELECTA 16 AgfaPhoto SELECTA 16
73
AgfaPhoto SELECTA 16 AgfaPhoto SELECTA 16
Connecting the camera and printer.
1. Make sure both the camera and printer are turned on.
2. Connect one end of the supplied USB cable to the USB
port on your camera.
3.
Connect the other end of the cable to the USB port on
the printer.
If the camera is not connected to a PictBridge compatible
printer, the following error message will appear on the LCD
screen.
The above error message would also appear if the
USB mode were set incorrectly, in which case you
should disconnect the USB cable, check the USB
mode settings, ensure that the Printer is turned on,
and then try connecting the USB cable again.