EasyManua.ls Logo

Agilent Technologies 1260 Infinity G1315C - Optical System

Agilent Technologies 1260 Infinity G1315C
314 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Agilent 1260 Infinity DAD and MWD User Manual 11
Introduction
1
Optical System
Optical System
The optical system of the detector is shown in Figure below. Its illumination
source is a combination of a deuterium-arc-discharge lamp for the ultraviolet
(UV) wavelength range and a tungsten lamp for the visible (VIS) and
short-wave near-infrared (SWNIR) wavelength range. The image of the
filament of the tungsten lamp is focused on the discharge aperture of the
deuterium lamp by means of a special rear-access lamp design which allows
both light sources to be optically combined and share a common axis to the
source lens. The achromat (source lens) forms a single, focused beam of light
through the flow cell. Each cell room and lamp are separated by a quartz
window which can be cleaned or replaced. In the spectrograph, light is being
dispersed onto the diode array by a holographic grating. This allows
simultaneous access to all wavelength information.
Figure 1 Optical System of the Detector
7XQJVWHQODPS
'HXWHULXPODPS
+ROPLXPR[LGHILOWHU
$FKURPDWVRXUFHOHQV
)ORZFHOO
6OLW
'LRGHDUUD\
*UDWLQJ
&HOOVXSSRUWZLQGRZ
6SHFWUROHQV
&RXSOLQJOHQV

Table of Contents

Related product manuals