Agilent Technologies 33250A - Remote Interface Reference

130
4
SCPI
Remote Interface Reference
• SCPI Command Summary, on page 131
• Simplified Programming Overview, on page 142
• Using the APPLy Command, on page 144
• Output Configuration Commands, on page 153
• Pulse Configuration Commands, on page 166
• Amplitude Modulation (AM) Commands, on page 169
• Frequency Modulation (FM) Commands, on page 172
• Frequency-Shift Keying (FSK) Commands, on page 176
• Frequency Sweep Commands, on page 179
• Burst Mode Commands, on page 187
•Triggering Commands, on page 195
• Arbitrary Waveform Commands, on page 198
• State Storage Commands, on page 209
• System-Related Commands, on page 213
• Interface Configuration Commands, on page 218
• RS-232 Interface Configuration, on page 219
• Phase-Lock Commands, on page 223
• The SCPI Status System, on page 225
• Status Reporting Commands, on page 235
• Calibration Commands, on page 239
• An Introduction to the SCPI Language, on page 241
• Using Device Clear, on page 246
SCPI
SCPI
If you are a first-time user of the SCPI language, please refer to these sections to become
familiar with the language before attempting to program the function generator.